Cisco Catalyst 4500 Power Supply PWR-C45-6000ACV Catalyst 4500 6000W AC dual input Power Supply (Data + PoE)

PWR-C45-6000ACV Specification

Note Power factor correction is a standard feature on all Catalyst 4500 E-series AC-input power supplies. PFC reduces the reactive component in the source AC current allowing higher power factors (typically 99 percent or better) and lower harmonic current components.

High-line (230 VAC nominal)—170 VAC (min) to 264 VAC (max)

16 A (max) @ 230 VAC (for each input)

1050 W operation (with one 120 VAC nominal input)

– 70.8 A @ 12 VDC (data only)

– 12.5 A @ 3.3 VDC (data only)

– 18.4 A @ –50 VDC (PoE if used)

2100 W operation (with two 120 VAC nominal inputs)

– 141.6 A @ 12 VDC (data only)

– 12.5 A @ 3.3 VDC (data only)

– 37.0 A @ –50 VDC (PoE if used)

3000 W operation (with one 230 VAC nominal input)

– 183.3 A @ 12 VDC (data only)

– 12.5 A @ 3.3 VDC (data only)

– 48 A @ –50 VDC (PoE if used)

6000 W operation (with two 230 VAC nominal inputs)

– 183.3 A @ 12 VDC (data only)

– 12.5 A @ 3.3 VDC (data only)

– 96 A @ –50 VDC (PoE if used)

LEDs and Meanings

Off—Source AC voltage falls below 70 VAC, is not present, or the power supply is turned off.

Off—Power supply fan failure is detected.

Off—DC-output voltage with acceptable margins.

Note For proper operation of the OUTPUT FAIL LED, systems with single power supplies must be configured with a minimum of one fan tray assembly and one supervisor engine. Systems with dual power supplies must have a minimum configuration of one fan tray assembly, one supervisor engine, and one additional module. Failure to meet these minimum configuration requirements can cause a false power supply output fail signal.